Post by mosix on Feb 11, 2016 13:09:56 GMT
Hello all,
I've installed the gateway on a raspberry,
and a node sketch on Arduino UNO.
I'm trying to send some packets from arduino to the gateway, but it doesn't work. Debugging I found that the execution of the sketch on ARDUINO stop at the command:
"radio.sendWithRetry(GATEWAYID, (const void*)(&theData), sizeof(theData));"
Looking at the serial monitor I've noted that if I turn OFF the RFM69HW (433MHz) detaching the power from the 3.3 pin (on Arduino), the execution code goes on.
The radio module is good.
Someone had this problem?
Thankyou
I've installed the gateway on a raspberry,
and a node sketch on Arduino UNO.
I'm trying to send some packets from arduino to the gateway, but it doesn't work. Debugging I found that the execution of the sketch on ARDUINO stop at the command:
"radio.sendWithRetry(GATEWAYID, (const void*)(&theData), sizeof(theData));"
Looking at the serial monitor I've noted that if I turn OFF the RFM69HW (433MHz) detaching the power from the 3.3 pin (on Arduino), the execution code goes on.
The radio module is good.
Someone had this problem?
Thankyou