Joshua
Junior Member
Posts: 75
|
Post by Joshua on Jan 13, 2018 19:05:31 GMT
This project is using a Moteino to replace an older Aeon Labs Zwave sensor. I only have motion, temperature, and humidity on this particular build. Parts list: - Moteino by Low Power labs.
- PowerShieldby Low Power Labs
- 3.7V 650mAh Lipo battery
- TD TAD-898 3.3v IR infrared sensor module. Be sure to insulate the bottom of this board to avoid shorting out on the Moteino
- L3d printed case. www.thingiverse.com/thing:2756189
- DTH11 digital temperature humidity sensor module
|
|
Joshua
Junior Member
Posts: 75
|
Post by Joshua on Jan 13, 2018 19:06:08 GMT
If anyone has the time, I'd love to add a photoresistor to the build. I don't know how to program it.
|
|
|
Post by papa on Jan 13, 2018 21:38:48 GMT
Check my thread How to Add a new node feature. It was about photo resistor
Thanks for contributing what you have made so far
|
|