[Solved] Serial monitor Garage door sensor printing trash

[sharky]

I wanted to test the RFM69HW chips so I soldered and wired it to the arduino. I also wired as described the ultrasonic distance sensor. I uploaded the gargage_node.ino to the arduino and the serial monitor looked like this: i.imgur.com/ysjAIHD.png

As I am concerned, it is supposed to start showing "Transmitting at 915 MHz", but it doesn't, and what it repeats is the output "Serial.println(buff);" what I think is the line 128 of the code in loop.

What am I doing wrong?

Thank you for your help

[kmac]

If you look at the code shown in your attached picture, the line:
#define SERIAL_BAUD 96000 has 1 too many zeros

[sharky]

Nov 24, 2015 19:02:19 GMT kmac said:

If you look at the code shown in your attached picture, the line:
#define SERIAL_BAUD 96000 has 1 too many zeros

It is shameful start this way in the forum.., I've been blind..

Thank you very much!